Range Rover Evoque: Rear End Sheet Metal Repairs - 5-Door
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Body and Paint / Rear End Sheet Metal Repairs - 5-Door
- Quarter Panel
- Rear Side Member Section
- Rear Side Member Closing Panel
- Spare Wheel Well
- Rear Wheelhouse Outer
- Rear Bumper Mounting
- Back Panel
- Rear Side Member Lower Side Extension
- Rear Lamp Mounting Panel
- Water Drain Panel Section
- Rear Wheelhouse Front Extension
- Inner Quarter Panel
- Front Inner Quarter Panel
- Rear Inner Quarter Panel
- Inner Quarter Panel and Wheelhouse
- Inner Back Panel Assembly
- Rear Side Member Upper Side Extension
READ NEXT:
Quarter Panel
Removal
NOTES:
Within this procedure there are 2 different options depending on type of
vehicle body and combination of replacement panels.
The quarter panel is manufactured from mild steel.
The ro
Rear Side Member Section
Removal
NOTES:
The rear side member section is manufactured from RP260, with its inner
reinforcement manufactured from DP600.
The rear side member section is cut from the rear side member service pa
Rear Side Member Closing Panel
Removal
NOTES:
The rear side member lower side extension is manufactured from DP600 with
a mild steel mounting bracket.
The panel is serviced less its weld studs.
1. The rear side
member closing
pan
SEE MORE:
Body Repairs - Vehicle Specific Information and Tolerance Checks
Body
and Frame
Front End Body Dimensions
NOTES:
All dimensions shown are in millimetres (mm).
Dimensions shown to holes, are always taken from/to the hole centre. They are
also always to the body panel
surface, not to the top of bolts or components.
Side Panel Dimensions
3-door version
5-d
Dual view selection
When the ignition is switched on or the audio
unit is turned on after being turned off, single
view mode will be the default view.
To select dual view, press the dual view hard
key on the fascia surround. See 111,
AUDIO/VIDEO CONTROLS.
Press again to display the dual view Options
menu. From h
© 2011-2026 Copyright www.rrevoque.org
