Range Rover Evoque: Fuel Tank and Lines - GTDi 2.0L Petrol
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Fuel System / Fuel Tank and Lines - GTDi 2.0L Petrol
- Fuel Tank and Lines - Component Location
- Fuel Tank and Lines - System Operation and Component Description
- Fuel Filter
- Fuel Tank
- Fuel Tank and Lines - Diagnosis and Testing
READ NEXT:
Fuel Tank and Lines - Component
Location
Component
Location
COMPONENT LOCATION - ROW
Connection to purge valve
Fuel Low Pressure (LP) sensor
Fuel fired booster heater - fuel supply pipe connection (if fitted)
LP fuel supply pipe
Fuel
Fuel Tank and Lines - System
Operation and Component Description
Control Diagram
NOTE: A = Hardwired
Battery
Battery Junction Box (BJB)
Fuel Pump Driver Module (FPDM)
Fuel pump delivery module
Engine Control Module (ECM)
Central Junction Box (CJB)
System O
Fuel Filter
Special Tool(s)
310-123
Locking Ring, Fuel Tank
Removal
WARNINGS:
Wait for a minimum of 1 minute after the engine has stopped before
carrying out any repair to the fuel injection
system.
Avoid flame
SEE MORE:
Fuel Charging and Controls - Turbocharger - GTDi 2.0L Petrol
Torque Specifications
Turbocharger
Removal
NOTES:
Some illustrations may show the engine removed for clarity.
Some variation in the illustrations may occur, but the essential information is
always correct.
Removal steps in this procedure may contain installation details.
1. Disconnect the batter
Accessory Drive - GTDi 2.0L Petrol
Torque Specifications
Accessory Drive Belt
Removal
NOTE: Some illustrations may show the engine removed for clarity.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. WARNING: Make sure to support the vehicle with axle stand
© 2011-2026 Copyright www.rrevoque.org - 0.0039
