Range Rover Evoque: Rear End Sheet Metal Repairs - 5-Door

READ NEXT:

 Quarter Panel

Removal NOTES: Within this procedure there are 2 different options depending on type of vehicle body and combination of replacement panels. The quarter panel is manufactured from mild steel. The ro

 Rear Side Member Section

Removal NOTES: The rear side member section is manufactured from RP260, with its inner reinforcement manufactured from DP600. The rear side member section is cut from the rear side member service pa

 Rear Side Member Closing Panel

Removal NOTES: The rear side member lower side extension is manufactured from DP600 with a mild steel mounting bracket. The panel is serviced less its weld studs. 1. The rear side member closing pan

SEE MORE:

  A-Pillar Trim Panel, B-Pillar Upper Trim Panel 5-Door

A-Pillar Trim Panel Removal NOTE: Removal steps in this procedure may contain installation details. 1. Torque: 6 Nm Installation 1. To install, reverse the removal procedure. B-Pillar Upper Trim Panel 5-Door Removal NOTE: Removal steps in this procedure may contain installation details. 1. 2. 3.

  B-Pillar Lower Trim Panel, D-Pillar Trim Panel

B-Pillar Lower Trim Panel Removal NOTE: Removal steps in this procedure may contain installation details. 1. 2. 3. 4. CAUTION: Discard the bolt. Torque: 45 Nm 5. 6. Installation 1. WARNING: Make sure that a new bolt is installed. CAUTION: Make sure the safety belt is secure and correctly inst

© 2011-2026 Copyright www.rrevoque.org - 0.0039