Range Rover Evoque manuals

Range Rover Evoque: Manual Transmission/Transaxle

Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Manual Transmission & Transaxle / Manual Transmission/Transaxle

READ NEXT:

 Manual Transmission AWD

Component Location COMPONENT LOCATION Manual transmission Selector lever assembly Overview OVERVIEW The M66EH50 manual transmission is a 6 speed unit manufactured by Getrag-Ford in Cologne, Germ

 Transmission Draining and Filling

WARNING: Observe due care when draining, as the fluid can be very hot. 1. WARNING: Make sure to support the vehicle with axle stands. NOTE: Make sure that the vehicle is standing on a level surface.

 Halfshaft Seal RH Vehicles With: M66 6-Speed Manual Transmission AWD

Special Tool(s) 303-1300 Remover, Crankshaft Seal 303-882 Installer, Halfshaft Seal Removal 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle. 2. Refer to: F

SEE MORE:

 Suspension Top Mount

Removal NOTES: The suspension top mount is manufactured from mild steel and RP220. The service panel is serviced not fully spot welded. The panel is serviced less its weld studs 1. In this procedure, to make sure the vehicle is correctly aligned, it must be placed on an approved alignment jig. 2.

 Rear Side Member Upper Side Extension

Removal NOTES: The rear side member upper side extension is manufactured from mild steel. If a new Rear side member upper side extension is being replaced in combination with a rear side member closing panel some MIG plug welds can be substituted for spot welds on installation within this procedu

© 2011-2025 Copyright www.rrevoque.org