Range Rover Evoque: Rear End Sheet Metal Repairs - 5-Door
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Body and Paint / Rear End Sheet Metal Repairs - 5-Door
- Quarter Panel
- Rear Side Member Section
- Rear Side Member Closing Panel
- Spare Wheel Well
- Rear Wheelhouse Outer
- Rear Bumper Mounting
- Back Panel
- Rear Side Member Lower Side Extension
- Rear Lamp Mounting Panel
- Water Drain Panel Section
- Rear Wheelhouse Front Extension
- Inner Quarter Panel
- Front Inner Quarter Panel
- Rear Inner Quarter Panel
- Inner Quarter Panel and Wheelhouse
- Inner Back Panel Assembly
- Rear Side Member Upper Side Extension
READ NEXT:
Quarter Panel
Removal
NOTES:
Within this procedure there are 2 different options depending on type of
vehicle body and combination of replacement panels.
The quarter panel is manufactured from mild steel.
The ro
Rear Side Member Section
Removal
NOTES:
The rear side member section is manufactured from RP260, with its inner
reinforcement manufactured from DP600.
The rear side member section is cut from the rear side member service pa
Rear Side Member Closing Panel
Removal
NOTES:
The rear side member lower side extension is manufactured from DP600 with
a mild steel mounting bracket.
The panel is serviced less its weld studs.
1. The rear side
member closing
pan
SEE MORE:
Temporary spare wheel
Always adhere to the
instructions
given on the temporary use spare
wheel warning label. Failure to
comply can be dangerous.
When a temporary use spare wheel is
fitted, drive with caution and replace
with the specified wheel and tyre as
soon as possible.
Do not fit more than one temporary
C-Pillar Upper Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3.
4.
5. Torque: 6 Nm
6.
Installation
1. To install, reverse the removal procedure.
C-Pillar Lower Trim Panel
Removal
1. Refer to: Rear Seat Cushion (501-10 Seating, Removal and
Installation).
2. Refer to: Lo
© 2011-2026 Copyright www.rrevoque.org
