Range Rover Evoque: Steering System

READ NEXT:

 Power Steering

 Power Steering AWD

Component Location Steering gear Rubber seal assembly Heat shield Overview The vehicle is fitted with EPS (electric power steering), provided by a ZF Servolectric steering gear unit with variab

 Steering Gear

Special Tool(s) 205-754A Splitter, Ball Joints 502-012 Alignment Pins, Subframe General Equipment Transmission jack Removal CAUTION: Nuts and bolts must be tightened with the weight of the vehicle

SEE MORE:

 Headlamps

Moving the nearside headlamp unit to access bulbs; 1. Remove the two plastic fixings. 2. Pull the tube up to release from the air box. This will allow more room for manoeuvrability. 3. Remove the four grille fixings. 4. Remove the two retaining bolts. 5. At the rear of the headlamp unit, p

 Replacement tyres

Do not fit cross ply tyres. Do not fit tubed tyres. Do not rotate tyres around the vehicle. If the use of tyres not recommended by Land Rover is unavoidable, ensure that you read and fully comply with the tyre manufacturer’s instructions. Ideally, tyres should be replaced in sets of 4. If

© 2011-2025 Copyright www.rrevoque.org