Component Location
Steering gear
Rubber seal assembly
Heat shield
Overview
The vehicle is fitted with EPS (electric power steering), provided by a ZF
Servolectric steering gear unit with variab
Special Tool(s)
205-754A
Splitter, Ball Joints
502-012
Alignment Pins, Subframe
General Equipment
Transmission jack
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle
Removal
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Exhaust System (309-00B Exhaust System - TD4 2.2L
Diesel, Removal and Installation).
3. CAUTION: Make sure that the driveshaft is
supported with suitable retaining straps.
4. CAUTIONS:
Removal
WARNING: This procedure involves fuel handling. Be prepared for fuel
spillage at all times and always observe fuel
handling precautions. Failure to follow these instructions may result in
personal injury.
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect