Range Rover Evoque: Exterior lights

READ NEXT:

 Lighting control

Lighting control 1. With the headlamps on, push the control away from the steering wheel to select high beam. The instrument pack warning lamp will illuminate. Note: Do not use high beam where

 Daytime running lamps

Daytime running lamps are LED lamps. With the lighting control in the OFF position or in AUTO position while lighting conditions do not require headlamps on, then daytime running lamps will switch

 Headlamp courtesy delay

This feature operates whenever the lamps master switch is in the AUTO (5) position and the ignition is turned off. The headlamps will remain illuminated for up to 240 seconds. Note: The time delay

SEE MORE:

 Checking the tyre pressures

Tyre information label location. Tyre pressures should be checked regularly using an accurate pressure gauge, when the tyres are cold. The following procedure should be used to check and adjust the tyres pressures. 1. Remove the valve cap. 2. Firmly attach a tyre pressure gauge/inflator

 Torque Converter Seal GTDi 2.0L Petrol

Special Tool(s) 307-597 Installer, Torque Converter Seal 307-613 Holding Pins, Torque Converter Removal NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. WARNING: Make sure to support the vehicle with axle stands. Raise and support the vehicle.

© 2011-2025 Copyright www.rrevoque.org