Range Rover Evoque: Body Closures
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Body and Paint / Body Closures
- Liftgate Alignment, Front Door
- Power Liftgate Switch, Liftgate
- Rear Door
- Fuel Filler Door
- Body Closures - Component Location, System Operation and Component Description
READ NEXT:
Liftgate Alignment, Front Door
Liftgate Alignment
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. With the liftgate closed, check the alignment of the
liftgate to the roof p
Power Liftgate Switch, Liftgate
Power Liftgate Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. Torque: 4 Nm
3. Torque: 4 Nm
4.
Installation
1. To install, reverse the removal procedur
Rear Door
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Disconnect the bat
SEE MORE:
Rear Halfshaft LH
Special Tool(s)
205-857
Remover, Halfshaft
205-928
Remover, Half Shaft Inboard Joint
Removal
CAUTIONS:
Nuts and bolts must be tightened with the weight of the vehicle on the
suspension.
Do not allow halfshafts to hang unsupported at one end or joint damage will
occur.
Make sure the halfshaft con
Front Side Member
Removal
NOTES:
The front side member is manufactured from RP260 and DP600.
The front side member long section is cut from the front side member and is
manufactured from RP260.
The service panel is serviced not fully spot welded.
1. In this procedure, to make sure the vehicle is correctly aligned,
© 2011-2026 Copyright www.rrevoque.org
