Range Rover Evoque: General program (special programs off)
This program is compatible with all
on and off-road conditions. If not
already active, it should be selected
before driving on surfaces which are similar to
a hard road surface. Dry cobbles, tarmac, dry
wooden planks, etc., all fall into this category.
This program should be selected once the need
for a special program has passed. Once the
special program has been deselected, all of the
vehicle systems will return to their normal
settings except HDC. HDC will remain active if
it was selected manually.
READ NEXT:
This program should be used
where a firm surface is covered
with loose or slippery material.
Note: For deep snow it is recommended that
the Sand program is selected.
Note: If the vehicle is una
This program should be used for
crossing terrain that is muddy,
rutted, soft or uneven. HDC is
automatically selected with this program.
This program should be used for
terrain which is predominantly soft
dry sand or deep gravel.
Note: If the vehicle is unable to gain traction in
extremely soft, dry sand, switching DSC off
may h
SEE MORE:
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some illustrations may show the engine removed for clarity.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Disconnect the battery ground cable.
Refer to: Specification
Emission Control -
Component Location
COMPONENT LOCATION
Intake manifold
Bolt (8 off)
Crankcase ventilation hose
Oil separator
Gasket
Camshaft cover
Lower clean air inlet duct
Upper clean air inlet duct
Camshaft cover vent hose
Air cleaner housing
Engine Emission Control -
Overview
OVER
© 2011-2024 Copyright www.rrevoque.org