Range Rover Evoque: Electronic Engine Controls - GTDi 2.0L Petrol
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Electronic Engine Controls - GTDi 2.0L Petrol
- Electronic Engine Controls - Component Location
- Electronic Engine Controls - System Operation and Component Description
- Crankshaft Position (CKP) Sensor
- Catalyst Monitor Sensor
- Electronic Engine Controls
READ NEXT:
Electronic Engine Controls -
Component Location
Component Location
COMPONENT LOCATION - SHEET 1 OF 4
Fuel metering valve - HP Fuel pump
Camshaft Position (CMP) sensor (2 off)
Variable Camshaft Timing (VCT) solenoid (2 off)
Purge valve
Genera
Control Diagram, System Operation
Control Diagram
NOTE: A = Hardwired; D = High Speed CAN Bus; O = Local Interconnect
Network (LIN) Bus
CONTROL DIAGRAM - SHEET 1 OF 2
Battery
Starter motor fuse
Battery Junction Box (BJB)
Starte
SEE MORE:
Direction indicator and side lamp bulbs
Removing the nearside bulbs;
To gain more room for accessibility, follow
steps 1 and 2 for moving the nearside
headlamp unit.
1. At the back of the headlamp unit, remove
the indicator bulb housing. Turn it counter
clockwise to release.
2. To remove the side lamp bulb housing.
Turn it count
Glass Roof Panel Blind
Removal
CAUTION: When removing and installing the glass roof panel blind, extreme
cleanliness must be observed at all
times.
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. NOTE: The procedure must be carried out on both sides.
Refer to: A-Pillar Trim Panel
© 2011-2025 Copyright www.rrevoque.org
