Component
Location
COMPONENT LOCATION
Manual transmission
Selector lever assembly
Overview
OVERVIEW
The M66EH50 manual transmission is a 6 speed unit manufactured by Getrag-Ford
in Cologne, Germ
WARNING: Observe due care when draining, as the fluid can be very hot.
1. WARNING: Make sure to support the vehicle with axle stands.
NOTE: Make sure that the vehicle is standing on a level
surface.
Special Tool(s)
303-1300
Remover, Crankshaft Seal
303-882
Installer, Halfshaft Seal
Removal
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: F
Windshield Wiper Motor
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Refer to: Plenum Chamber (412-01 Climate Control, Removal and
Installation).
2. NOTE: LHD illustration shown, RHD is similar.
Torque: 8 Nm
Installation
1. To install, reverse the removal proced
Torque Specifications
Rear Quarter Panel Moulding
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. NOTE: Discard the retaining clips.
Make sure that the centre part of the clip is fully
removed from the outer part of the clip. It is not
possible to prevent