Range Rover Evoque: Rear End Sheet Metal Repairs - 5-Door
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Body and Paint / Rear End Sheet Metal Repairs - 5-Door
- Quarter Panel
- Rear Side Member Section
- Rear Side Member Closing Panel
- Spare Wheel Well
- Rear Wheelhouse Outer
- Rear Bumper Mounting
- Back Panel
- Rear Side Member Lower Side Extension
- Rear Lamp Mounting Panel
- Water Drain Panel Section
- Rear Wheelhouse Front Extension
- Inner Quarter Panel
- Front Inner Quarter Panel
- Rear Inner Quarter Panel
- Inner Quarter Panel and Wheelhouse
- Inner Back Panel Assembly
- Rear Side Member Upper Side Extension
READ NEXT:
Quarter Panel
Removal
NOTES:
Within this procedure there are 2 different options depending on type of
vehicle body and combination of replacement panels.
The quarter panel is manufactured from mild steel.
The ro
Rear Side Member Section
Removal
NOTES:
The rear side member section is manufactured from RP260, with its inner
reinforcement manufactured from DP600.
The rear side member section is cut from the rear side member service pa
Rear Side Member Closing Panel
Removal
NOTES:
The rear side member lower side extension is manufactured from DP600 with
a mild steel mounting bracket.
The panel is serviced less its weld studs.
1. The rear side
member closing
pan
SEE MORE:
Front Wheel Bearing
Special Tool(s)
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
204-727A
Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-807
Installer, Front Wheel Bearing
JLR-204-808
Installer, Front Wheel Bearing
General Equipment
Copper Hammer
Hydraulic press
Bolt and Nut Identification
An ISO metric bolt or screw made of steel and larger than 6 mm in diameter
can be identified by either of the symbols ISO
M or M embossed or indented on top of the bolt head.
In addition to marks identifying the manufacturer, the top of the bolt head
is also marked with symbols indicating the
st
© 2011-2025 Copyright www.rrevoque.org
