Range Rover Evoque: Fuel Tank and Lines - GTDi 2.0L Petrol
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Fuel System / Fuel Tank and Lines - GTDi 2.0L Petrol
- Fuel Tank and Lines - Component Location
- Fuel Tank and Lines - System Operation and Component Description
- Fuel Filter
- Fuel Tank
- Fuel Tank and Lines - Diagnosis and Testing
READ NEXT:
Fuel Tank and Lines - Component
Location
Component
Location
COMPONENT LOCATION - ROW
Connection to purge valve
Fuel Low Pressure (LP) sensor
Fuel fired booster heater - fuel supply pipe connection (if fitted)
LP fuel supply pipe
Fuel
Fuel Tank and Lines - System
Operation and Component Description
Control Diagram
NOTE: A = Hardwired
Battery
Battery Junction Box (BJB)
Fuel Pump Driver Module (FPDM)
Fuel pump delivery module
Engine Control Module (ECM)
Central Junction Box (CJB)
System O
Fuel Filter
Special Tool(s)
310-123
Locking Ring, Fuel Tank
Removal
WARNINGS:
Wait for a minimum of 1 minute after the engine has stopped before
carrying out any repair to the fuel injection
system.
Avoid flame
SEE MORE:
Engine Mount LH/RH
Engine Mount LH
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
S
Wiring Harness - Description and Operation
Introduction
CAUTION: Do not use any other heat shrink sleeve other than the approved
glue lined heat shrink sleeve mentioned
in the repair procedure.
The purpose of this document is to promote quick and efficient minor repair
to harness connectors or cables using
approved methods and the wiring
© 2011-2025 Copyright www.rrevoque.org
