Range Rover Evoque: Rear End Sheet Metal Repairs - 5-Door
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Body and Paint / Rear End Sheet Metal Repairs - 5-Door
- Quarter Panel
- Rear Side Member Section
- Rear Side Member Closing Panel
- Spare Wheel Well
- Rear Wheelhouse Outer
- Rear Bumper Mounting
- Back Panel
- Rear Side Member Lower Side Extension
- Rear Lamp Mounting Panel
- Water Drain Panel Section
- Rear Wheelhouse Front Extension
- Inner Quarter Panel
- Front Inner Quarter Panel
- Rear Inner Quarter Panel
- Inner Quarter Panel and Wheelhouse
- Inner Back Panel Assembly
- Rear Side Member Upper Side Extension
READ NEXT:
Quarter Panel
Removal
NOTES:
Within this procedure there are 2 different options depending on type of
vehicle body and combination of replacement panels.
The quarter panel is manufactured from mild steel.
The ro
Rear Side Member Section
Removal
NOTES:
The rear side member section is manufactured from RP260, with its inner
reinforcement manufactured from DP600.
The rear side member section is cut from the rear side member service pa
Rear Side Member Closing Panel
Removal
NOTES:
The rear side member lower side extension is manufactured from DP600 with
a mild steel mounting bracket.
The panel is serviced less its weld studs.
1. The rear side
member closing
pan
SEE MORE:
Radiator
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Cooling System
Central
Junction Box (CJB)
CAUTIONS:
Diagnosis by substitution from a donor vehicle is NOT acceptable.
Substitution of control modules does not
guarantee confirmation of a fault, and may also cause additional faults in the
vehicle being tested and/or the donor vehicle
When probing connectors to take measurements in the co
© 2011-2025 Copyright www.rrevoque.org
