Range Rover Evoque: Body Closures
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Body and Paint / Body Closures
- Liftgate Alignment, Front Door
- Power Liftgate Switch, Liftgate
- Rear Door
- Fuel Filler Door
- Body Closures - Component Location, System Operation and Component Description
READ NEXT:
Liftgate Alignment, Front Door
Liftgate Alignment
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. With the liftgate closed, check the alignment of the
liftgate to the roof p
Power Liftgate Switch, Liftgate
Power Liftgate Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. Torque: 4 Nm
3. Torque: 4 Nm
4.
Installation
1. To install, reverse the removal procedur
Rear Door
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Disconnect the bat
SEE MORE:
Rear Door Trim Panel
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 1.3 Nm
2. Torque: 6 Nm
3. Torque: 6 Nm
4.
5.
6.
7. NOTE: Do not disassemble further if the
component is removed for access only.
8. Torque: 0.6 Nm
9.
10. Torque: 1 Nm
11.
Installation
1. To install,
Bumpers
Front Bumper Cover
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2.
3. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
4. NOTE: The step must be carried out on both sides.
Refer to: Fender Splash Shield (501-02 Front E
© 2011-2026 Copyright www.rrevoque.org
