Range Rover Evoque: Identification Codes
VIN Number
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
The body VIN is located behind the spare wheel well under the rear carpet.
Windscreen VIN - UK, Europe and ROW

Windscreen VIN - China only

VIN label - UK, Europe and ROW

- Type/Approval Number - If shown
- VIN Number
- Gross Vehicle Weight
- Gross Trailer Weight
- Front Axle Weight
- Rear Axle Weight
- Colour Code Group
VIN label - China

- Vehicle VIN Number
- Engine Type/Capacity/Power
- Occupancy
- Build Date
- Gross Vehicle Weight
- Gross Trailer Weight
VIN label - Gulf markets

- Build Date
- Model year
- Vehicle VIN Number
Tire Data Label - UK, Europe and ROW

- Tire Size
- Tire Pressures
Certification/Tire data label - NAS only

- Vehicle VIN Number
- Bar Code Identification
- Tire Pressures
Tire pressure label - Canada only

- Tire Pressures
- Vehicle VIN Number
- Vehicle Type
VIN number identification
VIN number - UK, EU and ROW



VIN number - NAS and Canada


2.2 Liter Diesel Engine Serial Number

The 2.2 Liter Diesel Engine Serial Number is stamped on the RH side of the
cylinder block.
2.0 Liter Petrol Engine Serial Number

The 2.0 Liter Petrol Engine Serial Number is etched into the RH side of the
engine block.
Automatic Transmission Serial Number

The Automatic Transmission Serial Number is stamped on the LH side of the
transmission casing.
Manual Transmission Serial Number

The Manual Transmission Serial Number is stamped on the transmission casing.
Rear Differential Serial Number

The Rear Differential Serial Number is stamped on the side of the
differential casing.
Power transfer unit

The number is stamped on the underside of the casing.
READ NEXT:
General
WARNING: The
following instructions must be adhered to before raising the vehicle off the
ground:
Position vehicle on a solid, level surface.
Apply the parking brake.
Select 'P' - PARK
Two-Post Lift
WARNING:
Make sure that the vehicle is stable before commencing work.
CAUTION: If
the drive shaft(s) are to be removed, release the parking brake and select
NEUTRAL 'N' in the
trans
SEE MORE:
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Removal steps in this procedure may contain installation details.
1. Raise the front seat to the highest position.
2. Disconnect the battery ground cable.
Refer to: Specifications (414-0
Special Tool(s)
204-250
Wheel bearing install and removal tool
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-809
Installer, Rear Wheel Bearing
JLR-204-810
Installer, Rear Wheel Bearing
General Equipment
Copper Hammer
Hydrau
© 2011-2025 Copyright www.rrevoque.org
