Range Rover Evoque: Front End Sheet Metal Repairs
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Body and Paint / Front End Sheet Metal Repairs
- Front Bumper Mounting
- Front Side Member
- Front Side Member and Suspension Top Mount Assembly
- Suspension Top Mount
- Front Side Member Section
- Fender Apron Panel Reinforcement
- Fender Apron Lower Panel
- Fender Apron Upper Panel
- Front Side Member Closing Panel
- Fender Apron Panel Front Reinforcement
READ NEXT:
Front Bumper Mounting
Removal
NOTE: The front bumper mounting is manufactured from HSLA300 and mild
steel.
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on
an approved alignment j
Front Side Member
Removal
NOTES:
The front side member is manufactured from RP260 and DP600.
The front side member long section is cut from the front side member and is
manufactured from RP260.
The service panel is
Front Side Member and Suspension Top Mount
Assembly
Removal
NOTES:
The front side member and suspension top mount assembly consists of the
front side member closing panel, fender apron panel front
reinforcement, fender apron lower panel, suspension to
SEE MORE:
Transfer Case Fluid
Level Check
CAUTION: The fluid filler plug is not a fluid level plug.
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Engine Undershield (501-02 Fron
Fuel Filler Door
Removal
CAUTION: Make sure to protect the paintwork.
1.
Installation
1.
Fuel Filler Door Assembly
Removal
WARNING: Avoid flames, sparks or lighted substances.
CAUTION: Extreme cleanliness must be exercised when handling these
components.
NOTES:
Removal steps in this procedure may contain installa
© 2011-2025 Copyright www.rrevoque.org
