Range Rover Evoque: Side Air Curtain Module
Removal
CAUTION: Do not allow the side air curtain module to twist. Failure to follow this instruction may result in damage to the component.
NOTES:
Removal steps in this procedure may contain installation details.
RH illustration shown, LH is similar.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables, Specifications).
2. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General Information, Description and Operation).
3. Refer to: Headliner (501-05 Interior Trim and Ornamentation, Removal and Installation).
4. Torque: 10 Nm
5. Torque: 10 Nm
6. CAUTION: Take extra care not to damage the wiring harnesses.
7. CAUTIONS:
Take extra care not to damage the component.
Note the fitted position of the component prior to removal.
NOTE: Make sure that the component is installed to the position noted on removal.
Torque: 10 Nm
Installation
1. NOTE: If the original component is to be installed, then the washers on the retaining bolts will require loosening to aid the location of the retaining hooks. If a new component is being installed this instruction will not be required.
2. To install, reverse the removal procedure.
3. If a new component has been installed, configure using Land Rover approved diagnostic equipment.
READ NEXT:
Clockspring
Removal
CAUTION: Make sure that the road wheels are in the straight ahead
position.
NOTE: Removal steps in this procedure may contain installation details.
1. Make the SRS system safe.
Refer to: St
Air Bag and Safety Belt Pretensioner
Supplemental Restraint System (SRS)
Principle of Operation
For a detailed description of the supplemental restraints system and
operation, refer to the relevant Description and
Operation section in the workshop manual. REFER to: (501-2
Side Air Bag Module Vehicles With: Sports
Seats
Removal
WARNINGS:
To avoid accidental deployment and possible personal injury, the backup
power supply must be depleted before
repairing or replacing any air bag supplemental restraint system (SRS)
SEE MORE:
Roof Panel Vehicles Without: Sliding
Roof Opening Panel
Removal
NOTES:
The roof panel is manufactured from aluminium 6111T4.
The screw in studs must be renewed with the installation of a new roof panel.
1. The roof panel is replaced in conjunction with:
Liftgate
Windshield
Headliner
2. For additional information relating to this repair procedure p
Seats - System Operation and Component Description
Control Diagram
NOTE: A = Hardwired; N = Medium speed CAN (controller area network) bus; O
= LIN (local interconnect network)
bus
CONTROL DIAGRAM - FRONT POWER OPERATED NON-MEMORY SEATS
Driver seat forward-rearward motor
Driver seat recline motor
Driver seat height motor
Driver lumbar pump
D
