Range Rover Evoque: Body and Paint

READ NEXT:

 Front End Body Panels

Torque Specifications Fender Removal NOTE: Removal steps in this procedure may contain installation details. 1. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installation). 2. WARNING: Ma

 Body Closures

 Liftgate Alignment, Front Door

Liftgate Alignment NOTE: Some variation in the illustrations may occur, but the essential information is always correct. 1. With the liftgate closed, check the alignment of the liftgate to the roof p

SEE MORE:

  Programming

Programming With the engine switched off; 1. Ensure that the ignition system is on. 2. Hold the signal emitting end of the original garage door opener hand-held transmitter 50 to 150 mm (2 to 6 inches) away from the HomeLink transceiver in the rear-view mirror, keeping the indicator lamp in

  Rolling code device equipment programming

Note: The assistance of a second person, may make the following steps quicker and easier. Once the button has been pressed there are only 30 seconds in which to complete Step 3. 1. At the garage door opener receiver (motor head unit) in the garage, locate the learn or smart button/switch. - T

© 2011-2026 Copyright www.rrevoque.org - 0.0102