Removal
NOTES:
The side panel is manufactured from mild steel. The fender mounting
bracket is serviced on the new panel.
This procedure identifies the method for the replacement of the side panel in
Removal
NOTES:
The A-pillar outer panel is manufactured from mild steel. The fender
mounting bracket is serviced on the new panel.
The upper and lower butt joint must be MIG brazed due to the locati
Removal
NOTES:
The A- Pillar reinforcement is manufactured from DP600, it is serviced
with its upper and lower door hinge mounting
brackets.
The A-Pillar reinforcement is unpicked from the side pane
Steering Angle Sensor Module (SASM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle
NOTES:
I
Component Location
RH (right-hand) spring and damper assembly
Stabilizer link
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Hub
Longitudinal link
Rear transverse link
Front transverse link
Subframe
Overview
The rear suspension features long travel McPherson stru