Range Rover Evoque: Body Closures
READ NEXT:
Liftgate Alignment
NOTE: Some variation in the illustrations may occur, but the essential
information is always correct.
1. With the liftgate closed, check the alignment of the
liftgate to the roof p
Power Liftgate Switch
Removal
NOTE: Removal steps in this procedure may contain installation details.
1.
2. Torque: 4 Nm
3. Torque: 4 Nm
4.
Installation
1. To install, reverse the removal procedur
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Disconnect the bat
SEE MORE:
WARNING: Observe due care when draining, as the fluid can be very hot.
1. WARNING: Make sure to support the vehicle with axle stands.
NOTE: Make sure that the vehicle is standing on a level
surface.
Raise and support the vehicle.
2. Refer to: Engine Undershield (501-02 Front End Body Panels,
Remo
Do not fit cross ply tyres.
Do not fit tubed tyres.
Do not rotate tyres around the vehicle.
If the use of tyres not recommended by
Land Rover is unavoidable, ensure
that you read and fully comply with the
tyre manufacturer’s instructions.
Ideally, tyres should be replaced in sets of 4. If
© 2011-2026 Copyright www.rrevoque.org
