Range Rover Evoque: Starting the engine
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Starting the engine
- Switching on the ignition
- Engine starting
- Engine starting: automatic transmission
- Engine starting: manual transmission
- If the engine fails to start
- Switching off the engine
- Switching off the engine with the vehicle moving
- Rolling re-start
- Keyless start backup
- Stop/start (manual transmission only)
- Conditions preventing automatic engine stop
- Conditions causing automatic engine restart
- Disabling stop/start
- Eco stall recovery
- Emission control system
- Diesel particulate filter (DPF)
READ NEXT:
Switching on the ignition
To turn on the ignition without starting the
engine:
- Do not depress the brake/clutch pedal,
- Press the START/STOP button and hold
until the warning lamps illuminate, then
release the button.
Engine starting
Never start the engine, or
leave it
running, when the vehicle is in an
enclosed space. Exhaust gasses are
poisonous and can cause
unconsciousness and death if inhaled.
If the engine fails to
Engine starting: automatic transmission
1. A valid Smart Key must be inside the
vehicle.
2. Make sure the gear selector is in P or N.
3. Firmly depress the brake pedal.
4. Press and release the start button. The
engine will crank autom
SEE MORE:
Generator and Regulator - GTDi 2.0L Petrol
Generator - Component
Location
COMPONENT LOCATION
Battery positive connection
LIN (local interconnect network) bus connection
Generator
Generator - Overview
OVERVIEW
A single self-exciting generator is located at the front of the engine on the
LH (left-hand) side of the cylinder block. There
Rear Door
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
© 2011-2025 Copyright www.rrevoque.org
