Range Rover Evoque: Front End Sheet Metal Repairs
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Body and Paint / Front End Sheet Metal Repairs
- Front Bumper Mounting
- Front Side Member
- Front Side Member and Suspension Top Mount Assembly
- Suspension Top Mount
- Front Side Member Section
- Fender Apron Panel Reinforcement
- Fender Apron Lower Panel
- Fender Apron Upper Panel
- Front Side Member Closing Panel
- Fender Apron Panel Front Reinforcement
READ NEXT:
Front Bumper Mounting
Removal
NOTE: The front bumper mounting is manufactured from HSLA300 and mild
steel.
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on
an approved alignment j
Front Side Member
Removal
NOTES:
The front side member is manufactured from RP260 and DP600.
The front side member long section is cut from the front side member and is
manufactured from RP260.
The service panel is
Front Side Member and Suspension Top Mount
Assembly
Removal
NOTES:
The front side member and suspension top mount assembly consists of the
front side member closing panel, fender apron panel front
reinforcement, fender apron lower panel, suspension to
SEE MORE:
Catalyst Monitor Sensor
Special Tool(s)
310-121
Wrench, H02S
Removal
WARNING: Observe due care when working near a hot exhaust system.
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Disconnect the batt
Throttle Body
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some illustrations may show the engine removed for clarity.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Engine Cover - GTDi 2.0L Petrol (501-05 Interior Tr
© 2011-2025 Copyright www.rrevoque.org
