Range Rover Evoque: Front End Sheet Metal Repairs
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Body and Paint / Front End Sheet Metal Repairs
- Front Bumper Mounting
- Front Side Member
- Front Side Member and Suspension Top Mount Assembly
- Suspension Top Mount
- Front Side Member Section
- Fender Apron Panel Reinforcement
- Fender Apron Lower Panel
- Fender Apron Upper Panel
- Front Side Member Closing Panel
- Fender Apron Panel Front Reinforcement
READ NEXT:
Front Bumper Mounting
Removal
NOTE: The front bumper mounting is manufactured from HSLA300 and mild
steel.
1. In this procedure, to make sure the vehicle is correctly aligned, it must
be placed on
an approved alignment j
Front Side Member
Removal
NOTES:
The front side member is manufactured from RP260 and DP600.
The front side member long section is cut from the front side member and is
manufactured from RP260.
The service panel is
Front Side Member and Suspension Top Mount
Assembly
Removal
NOTES:
The front side member and suspension top mount assembly consists of the
front side member closing panel, fender apron panel front
reinforcement, fender apron lower panel, suspension to
SEE MORE:
Land rover tyre repair kit
Land rover tyre repair kit
1. Maximum speed label. 80 km/h (50 mph).
2. Tyre inflation hose.
3. Inflation hose protective cap.
4. Inflation hose connector.
5. Compressor power cable.
6. Power cable connector.
7. Sealant bottle receiver cap (orange).
8. Sealant bottle receiver.
9. Sealant
Before programming
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best results, fit a new battery to the
hand-held transmitter of the garage door
opener (or other devic
© 2011-2025 Copyright www.rrevoque.org
