Range Rover Evoque: Supplemental Restraint System

READ NEXT:

 Air Bag Supplemental Restraint System (SRS)

Component Location COMPONENT LOCATION SHEET 1 OF 2 Battery ECM (engine control module) CJB (central junction box) Passenger air bag Overhead console RCM (restraints control module) Driver air

 Restraints Control Module (RCM)

Removal NOTES: The RCM must be replaced after every time any SRS component has been deployed. Removal steps in this procedure may contain installation details. 1. Make the SRS system safe. Refer to

 Side Air Bag Module

Removal NOTE: Removal steps in this procedure may contain installation details. All vehicles 1. Make the SRS system safe. Refer to: Standard Workshop Practices (100-00 General Information, Descripti

SEE MORE:

 Inner Back Panel Assembly

Removal NOTES: The inner back panel assembly is manufactured from mild steel. The panel is serviced less its weld studs. The new service panel is not fully spot welded when supplied. It is necessary to remove a section of one rear lamp mounting panel to enable removal and installation of the inn

 Electric seats

Electric seats 1. Lumbar support adjustment. 2. Backrest adjustment. 3. Head restraint adjustment. 4. Height adjustment. 5. Forward and back adjustment. 6. Cushion angle adjustment. To adjust the seats, the Smart Key must be inside the vehicle. Do not adjust the seat while the vehicle

© 2011-2026 Copyright www.rrevoque.org