Range Rover Evoque: Front Suspension
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Suspension / Front Suspension
- Front Suspension - Component Location, System Operation and Component Description
- Front Wheel Bearing
- Lower Arm
- Front Stabilizer Bar AWD
- Front Stabilizer Bar Bushing
- Wheel Knuckle
- Front Shock Absorber Vehicles Without: Dynamic Suspension
- Shock Absorber and Spring Assembly Vehicles Without: Dynamic Suspension
- Front Shock Absorber Vehicles With: Dynamic Suspension
- Shock Absorber and Spring Assembly Vehicles With: Dynamic Suspension
READ NEXT:
Front Suspension - Component Location, System Operation and Component Description
Component Location
RH (right-hand) spring and damper assembly
Stabilizer bar link
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Hub and bearing assembly
Lower control
Front Wheel Bearing
Special Tool(s)
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
204-727A
Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-807
Installer, Front Wheel B
Lower Arm
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle
on the suspension.
NOTES:
RH illustration shown, LH is similar.
Removal steps in this procedure may contain installat
SEE MORE:
Battery and Cables AWD
Component
Location
COMPONENT LOCATION - SHEET 1 OF 2 - DW12c
CJB (central junction box)
ECM (engine control module)
RJB (rear junction box)
Battery
BJB (battery junction box)
Starter motor
Generator
COMPONENT LOCATION - SHEET 2 OF 2 - GTDi
CJB
ECM
RJB
Battery
BJB
Starter motor
Gen
Trailer electrical connection
Connect only approved
electrical
circuits, which are in good condition, to
the trailer socket.
The vehicle connector provides a 5 amp output
which must not be exceeded. An accessory
harness kit increasing output to 15 amp is
available from your Land Rover Dealer.
When a trailer electrica
© 2011-2025 Copyright www.rrevoque.org
