Control Diagram
NOTE: A = Hardwired; D = High Speed Controller Area Network (CAN) bus; O =
Local Interconnect Network ( LIN)
Battery
Battery Junction Box (BJB)
Engine Control Module (ECM)
Centr
TORQUE CONVERTER
Torque converter housing
Lock-up clutch
Turbine
Impeller
Stator
Fluid pump
Input shaft
The torque converter is the coupling element between the engine and the
transmission
Take note of all warnings
and
instructions given on the label affixed
to the inside of the filler flap.
The fuel filler flap is located on the right-hand
side of the vehicle, at the rear.
1. If a locking fuel filler flap is fitted, ensure
that the vehicle alarm system is disarmed.
Note: Th
Removal
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
2. Make the SRS system safe.
Refer to: Standard Workshop Practices (100-00 General In