Range Rover Evoque: Front Suspension
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Suspension / Front Suspension
- Front Suspension - Component Location, System Operation and Component Description
- Front Wheel Bearing
- Lower Arm
- Front Stabilizer Bar AWD
- Front Stabilizer Bar Bushing
- Wheel Knuckle
- Front Shock Absorber Vehicles Without: Dynamic Suspension
- Shock Absorber and Spring Assembly Vehicles Without: Dynamic Suspension
- Front Shock Absorber Vehicles With: Dynamic Suspension
- Shock Absorber and Spring Assembly Vehicles With: Dynamic Suspension
READ NEXT:
Front Suspension - Component Location, System Operation and Component Description
Component Location
RH (right-hand) spring and damper assembly
Stabilizer bar link
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Hub and bearing assembly
Lower control
Front Wheel Bearing
Special Tool(s)
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
204-727A
Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-807
Installer, Front Wheel B
Lower Arm
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle
on the suspension.
NOTES:
RH illustration shown, LH is similar.
Removal steps in this procedure may contain installat
SEE MORE:
Mirror dip when reversing
If the vehicle is equipped with memory seats,
when reverse gear is selected the door mirrors
can be set to automatically adjust, providing an
improved viewing angle of the curb side for
reversing. The Reverse-dip mirror feature
must be switched on. See 56, VEHICLE
INFORMATION AND SETTINGS MENU
Rear Bumper Mounting
Removal
NOTE: The rear bumper mounting is manufactured from mild steel.
1. In this procedure, to make sure the vehicle is correctly
aligned, it must be placed on an approved alignment
jig.
2. The rear bumper mounting is replaced in conjunction with:
Rear bumper cover
Rear bumper
Back panel
3.
© 2011-2025 Copyright www.rrevoque.org
