Range Rover Evoque: Front Suspension
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Suspension / Front Suspension
- Front Suspension - Component Location, System Operation and Component Description
- Front Wheel Bearing
- Lower Arm
- Front Stabilizer Bar AWD
- Front Stabilizer Bar Bushing
- Wheel Knuckle
- Front Shock Absorber Vehicles Without: Dynamic Suspension
- Shock Absorber and Spring Assembly Vehicles Without: Dynamic Suspension
- Front Shock Absorber Vehicles With: Dynamic Suspension
- Shock Absorber and Spring Assembly Vehicles With: Dynamic Suspension
READ NEXT:
Front Suspension - Component Location, System Operation and Component Description
Component Location
RH (right-hand) spring and damper assembly
Stabilizer bar link
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Hub and bearing assembly
Lower control
Front Wheel Bearing
Special Tool(s)
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
204-727A
Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-807
Installer, Front Wheel B
Lower Arm
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle
on the suspension.
NOTES:
RH illustration shown, LH is similar.
Removal steps in this procedure may contain installat
SEE MORE:
Charging or replacing the vehicle battery
If the vehicle battery should require charging,
the battery must be removed from the vehicle.
Consult your Dealer/Authorised Repairer.
Battery disconnection,
removal and
replacement should be carried out only
by qualified personnel. Consult your
Dealer/Authorised Repairer.
Used batteries
Fuse box locations
Fuse box locations
When a fuse box lid is
removed, take
care to protect the box from moisture,
and refit the lid at the earliest
opportunity.
Engine compartment - fuse box access:
1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
3. Delatch the tabs. Th
© 2011-2026 Copyright www.rrevoque.org - 0.0057
