Range Rover Evoque: Navigation system
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Navigation system
- The navigation system
- Things you need to know
- Accessing navigation
- Vehicle position error
- Navigation controls
- Map split screen
- Screen modes
- Search area
- Setting a destination
- Start guidance
- Easy route
- Learn route
- Voice guidance
- Stop route guidance
- Quick poi selection
- Restore system defaults
- Memory points
- Memory point details
- Postcode
- Emergency
- Map
- Coordinates
- Previous
- Motorway
- Points of interest (POI)
- Dealer locations
- Entry by town
- Poi categories and sub-categories
- Search area
- List soft key
- All softkey
- Local poi search
- Rds-tmc overview
- Rds-tmc display
- Rds-tmc icons
- Level 1 tmc event icons
- Level 2 tmc event icons
- Using tmc
- Ordnance survey data
- Ownership
- Licence grant
- Licence terms
- Limitations of use
- Limitation of liability
- Navteq corporation
- Ownership
- Licence grant
- Limitations of use
- Transfer
- Disclaimer of warranty
- Limitation of liability
- Government end users
- European declaration of conformity
READ NEXT:
The navigation system
Navigation instruction is by map and turn
information displayed on the touch screen and
can be complemented by voice guidance if
required. The system uses signals from Global
Positioning System (G
Things you need to know
Operate the system only when
it is
safe to do so.
The requirements of national Road Traffic
Regulations always apply.
Observation of traffic signs and local traffic
regulations always take pri
Accessing navigation
From the Home menu touch the On road nav
soft key. Alternatively press the NAV hard key
on the facia. A caution screen will be displayed.
If the navigation screen language has not been
set, now is
SEE MORE:
Block Heater
Removal
1. Refer to: Cooling System Partial Draining, Filling and Bleeding
(303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
2. Refer to: Engine Undershield (501-02 Front End Body Panels,
Removal and Installation).
3. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and
Installat
Front Side Member
Removal
NOTES:
The front side member is manufactured from RP260 and DP600.
The front side member long section is cut from the front side member and is
manufactured from RP260.
The service panel is serviced not fully spot welded.
1. In this procedure, to make sure the vehicle is correctly aligned,
© 2011-2025 Copyright www.rrevoque.org
