Range Rover Evoque: Navigation system
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Navigation system
- The navigation system
- Things you need to know
- Accessing navigation
- Vehicle position error
- Navigation controls
- Map split screen
- Screen modes
- Search area
- Setting a destination
- Start guidance
- Easy route
- Learn route
- Voice guidance
- Stop route guidance
- Quick poi selection
- Restore system defaults
- Memory points
- Memory point details
- Postcode
- Emergency
- Map
- Coordinates
- Previous
- Motorway
- Points of interest (POI)
- Dealer locations
- Entry by town
- Poi categories and sub-categories
- Search area
- List soft key
- All softkey
- Local poi search
- Rds-tmc overview
- Rds-tmc display
- Rds-tmc icons
- Level 1 tmc event icons
- Level 2 tmc event icons
- Using tmc
- Ordnance survey data
- Ownership
- Licence grant
- Licence terms
- Limitations of use
- Limitation of liability
- Navteq corporation
- Ownership
- Licence grant
- Limitations of use
- Transfer
- Disclaimer of warranty
- Limitation of liability
- Government end users
- European declaration of conformity
READ NEXT:
The navigation system
Navigation instruction is by map and turn
information displayed on the touch screen and
can be complemented by voice guidance if
required. The system uses signals from Global
Positioning System (G
Things you need to know
Operate the system only when
it is
safe to do so.
The requirements of national Road Traffic
Regulations always apply.
Observation of traffic signs and local traffic
regulations always take pri
Accessing navigation
From the Home menu touch the On road nav
soft key. Alternatively press the NAV hard key
on the facia. A caution screen will be displayed.
If the navigation screen language has not been
set, now is
SEE MORE:
Windshield Glass
Removal
CAUTIONS:
Always protect paintwork and glass when removing exterior components.
Always protect the interior components when removing body glass.
Lay the glass on felt covered supports. Do not stand on edge as this can cause
chips which subsequently develop
into cracks.
NOTES:
The cutting
Bolt and Nut Identification
An ISO metric bolt or screw made of steel and larger than 6 mm in diameter
can be identified by either of the symbols ISO
M or M embossed or indented on top of the bolt head.
In addition to marks identifying the manufacturer, the top of the bolt head
is also marked with symbols indicating the
st
© 2011-2025 Copyright www.rrevoque.org
