Range Rover Evoque: Front Suspension
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Suspension / Front Suspension
- Front Suspension - Component Location, System Operation and Component Description
- Front Wheel Bearing
- Lower Arm
- Front Stabilizer Bar AWD
- Front Stabilizer Bar Bushing
- Wheel Knuckle
- Front Shock Absorber Vehicles Without: Dynamic Suspension
- Shock Absorber and Spring Assembly Vehicles Without: Dynamic Suspension
- Front Shock Absorber Vehicles With: Dynamic Suspension
- Shock Absorber and Spring Assembly Vehicles With: Dynamic Suspension
READ NEXT:
Front Suspension - Component Location, System Operation and Component Description
Component Location
RH (right-hand) spring and damper assembly
Stabilizer bar link
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Hub and bearing assembly
Lower control
Front Wheel Bearing
Special Tool(s)
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
204-727A
Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-807
Installer, Front Wheel B
Lower Arm
Removal
CAUTION: Nuts and bolts must be tightened with the weight of the vehicle
on the suspension.
NOTES:
RH illustration shown, LH is similar.
Removal steps in this procedure may contain installat
SEE MORE:
Glass Roof Panel Blind
Removal
CAUTION: When removing and installing the glass roof panel blind, extreme
cleanliness must be observed at all
times.
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. NOTE: The procedure must be carried out on both sides.
Refer to: A-Pillar Trim Panel
Replacing remote control batteries
Replacing remote control batteries
With the back of the remote control facing
upwards, use a coin or similar implement to
rotate the battery cover. Lift the cover off to
reveal the battery compartment. Remove the
old battery and, ensuring that the correct
polarity is maintained, insert a rep
© 2011-2025 Copyright www.rrevoque.org
