Range Rover Evoque: Navigation system
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Navigation system
- The navigation system
- Things you need to know
- Accessing navigation
- Vehicle position error
- Navigation controls
- Map split screen
- Screen modes
- Search area
- Setting a destination
- Start guidance
- Easy route
- Learn route
- Voice guidance
- Stop route guidance
- Quick poi selection
- Restore system defaults
- Memory points
- Memory point details
- Postcode
- Emergency
- Map
- Coordinates
- Previous
- Motorway
- Points of interest (POI)
- Dealer locations
- Entry by town
- Poi categories and sub-categories
- Search area
- List soft key
- All softkey
- Local poi search
- Rds-tmc overview
- Rds-tmc display
- Rds-tmc icons
- Level 1 tmc event icons
- Level 2 tmc event icons
- Using tmc
- Ordnance survey data
- Ownership
- Licence grant
- Licence terms
- Limitations of use
- Limitation of liability
- Navteq corporation
- Ownership
- Licence grant
- Limitations of use
- Transfer
- Disclaimer of warranty
- Limitation of liability
- Government end users
- European declaration of conformity
READ NEXT:
The navigation system
Navigation instruction is by map and turn
information displayed on the touch screen and
can be complemented by voice guidance if
required. The system uses signals from Global
Positioning System (G
Things you need to know
Operate the system only when
it is
safe to do so.
The requirements of national Road Traffic
Regulations always apply.
Observation of traffic signs and local traffic
regulations always take pri
Accessing navigation
From the Home menu touch the On road nav
soft key. Alternatively press the NAV hard key
on the facia. A caution screen will be displayed.
If the navigation screen language has not been
set, now is
SEE MORE:
Fuel Pump
Removal
WARNING: This procedure involves fuel handling. Be prepared for fuel
spillage at all times and always observe fuel
handling precautions. Failure to follow these instructions may result in
personal injury.
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect
Rear Side Member Closing Panel
Removal
NOTES:
The rear side member lower side extension is manufactured from DP600 with
a mild steel mounting bracket.
The panel is serviced less its weld studs.
1. The rear side
member closing
panel is replaced
2. For additional information relating to this repair procedure please see
the foll
© 2011-2025 Copyright www.rrevoque.org
