Range Rover Evoque: Rear Suspension
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Suspension / Rear Suspension
- Rear Suspension AWD
- Rear Wheel Bearing
- Front Lower Arm
- Rear Lower Arm AWD
- Rear Stabilizer Bar
- Wheel Knuckle
- Rear Shock Absorber Vehicles Without: Dynamic Suspension
- Shock Absorber and Spring Assembly Vehicles Without: Dynamic Suspension
- Wheel Knuckle Rear Bushing
- Rear Shock Absorber Vehicles With: Dynamic Suspension
- Shock Absorber and Spring Assembly Vehicles With: Dynamic Suspension
- Spring Vehicles Without: Dynamic Suspension
- Rear Lower Arm FWD
- Rear Suspension FWD
READ NEXT:
Rear Suspension AWD
Component Location
RH (right-hand) spring and damper assembly
Stabilizer link
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Hub
Longitudinal link
Rear transverse lin
Rear Wheel Bearing
Special Tool(s)
204-250
Wheel bearing install and removal tool
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-809
Installer, Re
Front Lower Arm
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Front wheel drive transmission illustrations shown, all wheel wheel drive
transmission
SEE MORE:
Glass Roof Panel Blind Motor
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
All vehicles
1. NOTE: The step must be carried out on both sides.
Refer to: A-Pillar Trim Panel (501-05 Interior Trim and
Rocker Panel
Removal
NOTES:
The rocker panel is manufactured from mild steel.
Some of the butt joints must be MIG brazed due to the location of boron
reinforcements.
1. This procedure
identifies the
method for the
replacement of
the rocker
panel in full.
The graphic
and table
identify
possible
alternative
sec
© 2011-2025 Copyright www.rrevoque.org
