Range Rover Evoque: Rear Suspension
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Suspension / Rear Suspension
- Rear Suspension AWD
- Rear Wheel Bearing
- Front Lower Arm
- Rear Lower Arm AWD
- Rear Stabilizer Bar
- Wheel Knuckle
- Rear Shock Absorber Vehicles Without: Dynamic Suspension
- Shock Absorber and Spring Assembly Vehicles Without: Dynamic Suspension
- Wheel Knuckle Rear Bushing
- Rear Shock Absorber Vehicles With: Dynamic Suspension
- Shock Absorber and Spring Assembly Vehicles With: Dynamic Suspension
- Spring Vehicles Without: Dynamic Suspension
- Rear Lower Arm FWD
- Rear Suspension FWD
READ NEXT:
Rear Suspension AWD
Component Location
RH (right-hand) spring and damper assembly
Stabilizer link
Stabilizer bar
LH (left-hand) spring and damper assembly
Wheel knuckle
Hub
Longitudinal link
Rear transverse lin
Rear Wheel Bearing
Special Tool(s)
204-250
Wheel bearing install and removal tool
204-305
Remover, Wheel Bearing
204-726
Remover/Installer, Wheel Bearing
JLR-204-806
Support Tool, Wheel Knuckle
JLR-204-809
Installer, Re
Front Lower Arm
Removal
NOTES:
Some variation in the illustrations may occur, but the essential
information is always correct.
Front wheel drive transmission illustrations shown, all wheel wheel drive
transmission
SEE MORE:
Block Heater
Removal
1. Refer to: Cooling System Partial Draining, Filling and Bleeding
(303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures).
2. Refer to: Engine Undershield (501-02 Front End Body Panels,
Removal and Installation).
3. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and
Installat
Cylinder Head Components - 2.0L GTDi
Component Description
Oil level gage
Spark plug (4 off)
Variable valve timing solenoid valve - Inlet camshaft
Variable valve timing solenoid valve - Exhaust camshaft
Ignition coil and plug cap (4 off)
Camshaft Position (CMP) sensor - Exhaust camshaft
CMP sensor - Inlet camshaft
Camshaft co
© 2011-2025 Copyright www.rrevoque.org
