Removal
CAUTIONS:
If a new component is to be installed, the Land Rover approved diagnostic
equipment must be connected prior to
removal, the data must then be downloaded from it and the keys (remote
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
All vehicles
1. Refer
Removal
NOTES:
The front side member is manufactured from RP260 and DP600.
The front side member section is cut from the front side member and is
manufactured from RP260.
This procedure is written for the LH front side member section replacement, the
LH and RH front side member sections differ i
Removal
NOTE: The fender apron panel reinforcement is manufactured from mild
steel.
1.
2. For additional information relating to this repair procedure please see
the
following:
For additional information, refer to: Health and Safety Precautions (100-00
General Information, Description and Operat