Range Rover Evoque: Electrical Distribution & Electronic Feature Group
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Electrical Distribution & Electronic Feature Group
- Module Communications Network
- Central Junction Box (CJB)
- Battery Junction Box (BJB) TD4 2.2L Diesel
- Battery Junction Box (BJB) GTDi 2.0L
- Communications Network - Overview, System Operation and Component Description
- Communications Network - Diagnosis and Testing
- Wiring Harnesses
- Wiring Harness - Description and Operation
- Engine Wiring Harness TD4 2.2L Diesel, Vehicles With: AWF21 6-Speed Automatic Transmission
- Engine Wiring Harness GTDi 2.0L Petrol
- Engine Wiring Harness TD4 2.2L Diesel, Vehicles With: M66 6-Speed Manual Transmission AWD/M66 6-Speed Manual Transmission FWD
- Anti-Theft - Active
- Anti-Theft - Passive
- Navigation System
- Multifunction Electronic Modules
READ NEXT:
Central Junction Box (CJB)
Removal
CAUTIONS:
If a new component is to be installed, the Land Rover approved diagnostic
equipment must be connected prior to
removal, the data must then be downloaded from it and the keys (remote
Battery Junction Box (BJB) TD4 2.2L
Diesel
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
All vehicles
1. Refer
SEE MORE:
Diesel engined vehicles
Do not use RME (bio-diesel)
except in
the case of those proprietary diesel
fuels which contain a mix of up to 7%.
Land Rover vehicles can accept no
responsibility for damage caused by
using RME in concentrations greater
than 7%.
Use only high quality diesel fuel according to
EN590 or equi
Sulphur content
If your vehicle is fitted
with a Diesel
Particulate Filter (DPF) the maximum
Sulphur content must not exceed
0.005%. Using an incorrect fuel will
cause serious damage to the DPF.
The Sulphur content of diesel used in Land
Rover vehicles should not exceed 0.3% (3000
parts per million).
In
© 2011-2026 Copyright www.rrevoque.org - 0.0049
