Range Rover Evoque: Engine (ignition) switch (vehicles without a smart key system)

Toyota Corolla Cross (2022-2023) Owner's Manual / Driving / Driving procedures / Engine (ignition) switch (vehicles without a smart key system)

Starting the engine

1. Check that the parking brake is set.

2. Check that the shift lever is in P.

Do not press the shift lever button after shifting the shit position to P.

3. Firmly depress the brake pedal.

4. Turn the engine switch to START to start the engine.

■If the engine does not start

The engine immobilizer system may not have been deactivated.

Contact your Toyota dealer.

■When the steering lock cannot be released

When starting the engine, the engine switch may seem stuck in OFF. To free it, turn the key while turning the steering wheel slightly left and right.

Driving procedures

WARNING

■When starting the engine

Always start the engine while sitting in the driver's seat. Do not depress the accelerator pedal while starting the engine under any circumstances. Doing so may cause an accident resulting in death or serious injury.

NOTICE

■When starting the engine

READ NEXT:

 Changing the engine switch positions

OFF ("LOCK" position) The key can be removed. (The key can be removed only when the shift lever is in P.) ACC ("ACC" position) Some electrical components such as the audio system can be used.

 Engine (ignition) switch (vehicles with a smart key system)

Performing the following operations when carrying the electronic key on your person starts the engine or changes engine switch modes. Starting the engine 1. Check that the parking brake is set. 2. C

 Stopping the engine

1. Stop the vehicle completely. 2. Set the parking brake, and shift the shift lever to P. Check the parking brake indicator is illuminated. Do not press the shift lever button after shifting the shi

SEE MORE:

 Electrical Precautions

General The following guidelines are intended to make sure the safety of the operator whilst preventing damage to the electrical and electronic components of this vehicle. Equipment Prior to commencing any test procedure on the vehicle, make sure that the relevant test equipment is working correct

 Control Diagram, System Operation

Control Diagram NOTE: A = Hardwired; D = High speed CAN (controller area network) bus; O = LIN (local interconnect network) bus Battery BJB (battery junction box) Front height sensor Rear height sensor Headlamp leveling control module Front right fog lamp Front left fog lamp Left side rep

© 2011-2023 Copyright www.rrevoque.org