Range Rover Evoque: Climate Control System
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Climate Control System
- Climate Control System - General Information
- Climate Control
- Air Distribution and Filtering
- Heating and Ventilation
- Air Conditioning
- Control Components - Component Location
- Control Components - System Operation and Component Description
- Condenser GTDi 2.0L Petrol
- Blower Motor LHD AWD/LHD FWD
- Blower Motor RHD AWD/RHD FWD, RHD
- Climate Control Assembly
- Evaporator LHD
- Evaporator RHD
- Evaporator Temperature Sensor
- Condenser TD4 2.2L Diesel
- Heater Core and Evaporator Core Housing
- Defrost Vent/Register Blend Door Actuator LHD AWD/LHD FWD
- Desiccant Bag GTDi 2.0L Petrol
- Control Components FWD - Overview
- Auxiliary Climate Control
READ NEXT:
Climate Control System - General Information
Climate Control
Lubricants, Fluids, Sealers and Adhesives
General Specification
Capacities
Refrigerant oil adding capacities for replacment parts
NOTE: Rotate the A/C compressor shaft at least 6 t
Air Distribution and Filtering
Component Location
NOTE: Right Hand Drive (RHD) shown, Left Hand Drive (LHD) similar
COMPONENT LOCATION
Passenger face level/side window register
Side window vent
Face level duct
Side window duc
SEE MORE:
Seat belts
Do not allow any water,
cleaning
products, or fabric from cloths to enter
the seat belt mechanism. Any
substance which enters the
mechanism may affect the
performance of the seat belt in an
impact.
Extend the seat belts fully, then use warm
water and a non-detergent soap to clean. Allow
To erase all programming
For first time programming, ensure that the
engine is switched off:
1. Ensure that the ignition is on (but with the
engine switched off).
2. Press and hold the two outer HomeLink
buttons. Keep the buttons pressed until the
indicator lamp begins to flash (this will take
approximately 20 second
© 2011-2026 Copyright www.rrevoque.org
