Principle of Operation
For a detailed description of the seating systems and operation, refer to the
relevant Description and Operation section of
the workshop manual. REFER to: Seats (501-10 Seating
Control Diagram
NOTE: A = Hardwired; N = Medium speed CAN (controller area network) bus; O
= LIN (local interconnect network)
bus
CONTROL DIAGRAM - FRONT POWER OPERATED NON-MEMORY SEATS
Driver sea
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Disconnect the battery ground cable.
Refer to: Specifications (414-01 Battery, Mounting and Cables,
Specifications).
Removal
NOTES:
It is necessary to remove the inner quarter panel to enable removal and
installation of the rear wheelhouse outer.
The rear wheelhouse outer is manufactured from mild steel.
This method describes the LH rear wheelhouse outer, the RH side is similar.
1. The rear wheelhouse outer is
Removal
NOTES:
The fender apron lower panel is manufactured from mild steel.
The panel is serviced less its weld studs
This method describes the LH fender apron lower panel, the RH side is similar.
1. The fender apron lower panel is replaced in conjunction with:
Front bumper cover
Front bumper