Range Rover Evoque: Engine - GTDi 2.0L Petrol
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Engine / Engine - GTDi 2.0L Petrol
- Engine - Component Location, System Operation and Component Description
- Engine Oil Draining and Filling, Camshafts
- Cylinder Head
- Engine Mount LH/RH
- Intake Manifold
- Oil Cooler
- Oil Pan
- Oil Pump
- Timing Chain
- Timing Cover
- Valve Cover
- Engine - Removal and Installation
- Engine Upper/Lower Support Insulator
- Oil Filter Housing
- Balance Shaft Assembly
- Engine - Diagnosis and Testing
- Engine Timing
READ NEXT:
Engine - Component Location, System Operation and Component
Description
Component Location
EXTERNAL VIEW
Overview
OVERVIEW
The 2.0L Gasoline Turbocharged Direct Injection (GTDi) engine is an in-line,
double overhead camshaft, 4 cylinder engine,
which is transverse mount
Cylinder Block Components - 2.0L GTDi
Component Description
Front crankshaft oil seal
Front cover assembly
Knock sensor - cylinders 1 and 2
Gasket - thermostat housing
Thermostat
Cylinder block
Knock sensor - cylinders 3 and 4
B
Cylinder Head Components - 2.0L GTDi
Component Description
Oil level gage
Spark plug (4 off)
Variable valve timing solenoid valve - Inlet camshaft
Variable valve timing solenoid valve - Exhaust camshaft
Ignition coil and plug cap
SEE MORE:
Towing the vehicle on four wheels
If the vehicle battery is
disconnected or
disabled, do NOT attempt to tow the
vehicle. Towing may result in serious
damage to the transmission.
The vehicle should NOT be towed on all four
wheels. However, if the vehicle cannot be
recovered by using the correct method, please
adhere to the
Glass Roof Panel Blind
Removal
CAUTION: When removing and installing the glass roof panel blind, extreme
cleanliness must be observed at all
times.
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
1. NOTE: The procedure must be carried out on both sides.
Refer to: A-Pillar Trim Panel
© 2011-2025 Copyright www.rrevoque.org
