Range Rover Evoque: Climate Control System
Land Rover Range Rover Evoque L538 (2011–2018) Service Manual / Climate Control System
- Climate Control System - General Information
- Climate Control
- Air Distribution and Filtering
- Heating and Ventilation
- Air Conditioning
- Control Components - Component Location
- Control Components - System Operation and Component Description
- Condenser GTDi 2.0L Petrol
- Blower Motor LHD AWD/LHD FWD
- Blower Motor RHD AWD/RHD FWD, RHD
- Climate Control Assembly
- Evaporator LHD
- Evaporator RHD
- Evaporator Temperature Sensor
- Condenser TD4 2.2L Diesel
- Heater Core and Evaporator Core Housing
- Defrost Vent/Register Blend Door Actuator LHD AWD/LHD FWD
- Desiccant Bag GTDi 2.0L Petrol
- Control Components FWD - Overview
- Auxiliary Climate Control
READ NEXT:
Climate Control System - General Information
Climate Control
Lubricants, Fluids, Sealers and Adhesives
General Specification
Capacities
Refrigerant oil adding capacities for replacment parts
NOTE: Rotate the A/C compressor shaft at least 6 t
Air Distribution and Filtering
Component Location
NOTE: Right Hand Drive (RHD) shown, Left Hand Drive (LHD) similar
COMPONENT LOCATION
Passenger face level/side window register
Side window vent
Face level duct
Side window duc
SEE MORE:
Exterior Front/Rear Door Handle
Exterior Front Door Handle
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
Make sure the door window glass is in the fully closed position.
1. Refer to: Front Door Tri
Tyre pressure compensation for low ambient temperature changes
A colder ambient local temperature will reduce
pressure within the tyre. An effect is to
decrease sidewall height and to increase tyre
shoulder wear with the potential for tyre failure.
Vehicle dynamics could also be adversely
affected.
Tyre pressures can be adjusted to compensate
before the
© 2011-2025 Copyright www.rrevoque.org
