Range Rover Evoque: Engine
- Engine System - General Information
- Engine - GTDi 2.0L Petrol
- Engine - Component Location, System Operation and Component Description
- Engine Oil Draining and Filling, Camshafts
- Cylinder Head
- Engine Mount LH/RH
- Intake Manifold
- Oil Cooler
- Oil Pan
- Oil Pump
- Timing Chain
- Timing Cover
- Valve Cover
- Engine - Removal and Installation
- Engine Upper/Lower Support Insulator
- Oil Filter Housing
- Balance Shaft Assembly
- Engine - Diagnosis and Testing
- Engine Timing
- Engine Cooling - GTDi 2.0L Petrol
- Engine Cooling - Component Location, System Operation and Component Description
- Cooling System Draining, Filling and Bleeding
- Radiator
- Cooling Fan
- Cooling System Partial Draining, Filling and Bleeding
- Engine Cooling - Diagnosis and Testing
- Block Heater
- Fuel Charging and Controls - GTDi 2.0L Petrol
- Fuel Charging and Controls - Component Location, System Operation and Component Description
- Throttle Body
- Fuel Rail
- Fuel Pump
- Fuel Charging and Controls - Turbocharger - GTDi 2.0L Petrol
- Accessory Drive - GTDi 2.0L Petrol
- Starting System - GTDi 2.0L Petrol
- Engine Ignition - GTDi 2.0L Petrol
- Engine Emission Control - GTDi 2.0L Petrol
- Intake Air Distribution and Filtering - GTDi 2.0L Petrol
- Evaporative Emissions - GTDi 2.0L Petrol
- Electronic Engine Controls - GTDi 2.0L Petrol
READ NEXT:
Engine System - General Information
Cylinder Head Gasket Selection TD4
2.2L Diesel
Special Tool(s)
303-979
Measuring Bridge, Piston Protusion
1. CAUTION: Make sure that the surface is clean and
free of foreign material.
Zero the gauge o
Engine - Component Location, System Operation and Component
Description
Component Location
EXTERNAL VIEW
Overview
OVERVIEW
The 2.0L Gasoline Turbocharged Direct Injection (GTDi) engine is an in-line,
double overhead camshaft, 4 cylinder engine,
which is transverse mount
SEE MORE:
Land rover tyre repair kit
Land rover tyre repair kit
1. Maximum speed label. 80 km/h (50 mph).
2. Tyre inflation hose.
3. Inflation hose protective cap.
4. Inflation hose connector.
5. Compressor power cable.
6. Power cable connector.
7. Sealant bottle receiver cap (orange).
8. Sealant bottle receiver.
9. Sealant
Engine Timing
Special Tool(s)
303-1565
Locking Tool, Camshaft
308-511
Installer, Transmission Output Shaft Seal
JLR-303-1594
Locking Tool, Driveplate
JLR-303-748
Locking Tool, Crankshaft
Activation
1.
2. Install the special tool.
Special Tool(s): JLR-303-748
3. Rotate the engine clockwise until the crankshaft
© 2011-2025 Copyright www.rrevoque.org
